- Tailored frequency response is smooth and extended. Tuned specifically for vocal applications
- Cardioid polar pattern picks up the most sound from in front of the microphone and some sound from the sides. Less susceptible to feedback in high volume settings.
- Dynamic cartridge has a simple, rugged coil. Handles extreme volume levels without distortion
- Integral "pop" filter reduces explosive breath sounds and wind noise.
- On/off switch for onstage control
- A rugged mic tuned to accentuate the clarity of lead and back-up vocals
- Microphone Type: Dynamic (moving coil)^Polar Pattern: Cardioid (unidirectional)
- Frequency Response: 60 to 15,000 Hz
- Polarity: Positive pressure on diaphragm produces positive voltage on pin 2 relative to pin 3 of microphone output connector
Buy Shure PG58-QTR Cardioid Dynamic Vocal Microphone with 1/4-inch Cable Now
This is a GREAT mic! I bought it specifically for Karaoke. It is used along side a well worn SM58 and you know what? It actually sounds better than it's more expensive counterpart. Granted it is 20 years newer, but hey...It's great. It makes my crappy voice sound great when singing Karaoke and thats all I care about! For the price, it's a decent mic.It came with a mic stand holder, a case and a double ended XLR cable. Perfect for my needs. Shure makes good stuff!
Read Best Reviews of Shure PG58-QTR Cardioid Dynamic Vocal Microphone with 1/4-inch Cable Here
Purchased 2 of these for a gig and they performed as good as our SM58's, no problem.Want Shure PG58-QTR Cardioid Dynamic Vocal Microphone with 1/4-inch Cable Discount?
A solid entry level mic. Not as much gain nor is the shock mounting as good as the SM58, but better than anything else I have found at this price. Best as a mic for spoken word use, but not bad as a vocal or instrument mic. On the other hand if you drop the $$$ on say an AKG-535 you will notice a huge difference. It is a dynamic mic. so it has to be used in very close proximity to the source, so don't expect it (or any mic like it) to pick up much once it is more than a few inches from the source. Pretty rugged and reliable, and the cable isn't bad.NOTE: if you plan to plug this mic into a 1/4" input make sure you get a transformer and not just an adapter. XLR and 1/4" inputs have a different impedance, without the transformer your gain (signal level) will be very low!I bought this mic for use doing interviews. The reviews I read said it had great mic isolation and had very little handling noise. This is NOT true. Just holding the mic as stationary as you possibly can you will hear handling noise. If you mount it to a mic stand and anything touches it, you will hear that noise in your recording. I spoke with an engineer at Shure and he said that this is not the mic for handheld use. It's an entry level mic that is very limited in how it can be effectively used without tons of handling noise.


0 comments:
Post a Comment